Sylph-D200 MKII TPA3255 Stereo Amplifier Module (Ready to Run)

$148.00 USD - $158.00 USD

Mid-power chip-based class-D amplifier with sound improvements through optimization and careful parts selection.

The analog input can accept full balanced or single ended signals which can be configured by a solder jumper under the PCB. The output is 2 channel, stereo BTL configuration. Single ended input is enabled by default unless otherwise requested.

A split supply is used in the opamp buffer section in order to delete the redundant input coupling caps in the frontend audio path. The opamp rail supplies are being generated on-board with positive and negative post regulators.

The board has a standard PFFB configuration from SLAA788A. PFFB is disabled by default and can be enabled/disabled through onboard jumpers (power supply should be fully turned off).

Capacitor for PVDD is either United Chemi-con KZN / KYB Series or Panasonic FC series whichever is available.

Package Includes
1 pc Sylph-D200 Mark II stereo Ready to Run module.
2 pc female 2.54 mm 3 pin connector.

Specifications
Supply Voltage: 24V DC min to 51V DC max
Unclipped Power (50V Supply): 100W-8Ω, 200W-4Ω per ch
Output Power (50V Supply): up to 300W-4Ω per ch
Input sensitivity - SE (PFFB disabled): 1V RMS
Input sensitivity - SE (PFFB enabled): 2V RMS
Input sensitivity - Balanced (PFFB disabled): 2V RMS
Input sensitivity - Balanced (PFFB enabled): 4V RMS
Input impedance: 10K Ω
Input configuration: SE / Balanced (solder jumper)
Load impedance: 4Ω or 8Ω
Idle dissipation: ~7.5W at 50V DC
Footprint: 150mm x 100mm x 45mm (L * W * H)
Number of PCB Layers: 2 layer copper
Overcurrent /short protection: Yes
Over voltage protection: Yes
Overheat protection: Yes
Turn on-off pop suppression: Yes
Gross packed weight: 500g

Recommended Power Supply
(NOT INCLUDED)
- 48V DC Single supply SMPS 350W or higher.
- DO NOT use power supply with split rails.
- Mean Well LRS-350-48, or other 48V to 50V SMPS
- Use 44V DC for unregulated linear supplies

Shipping
Shipments are consolidated once a week. Kindly wait for the tracking info to become available. Courier is a European Postal affiliated company with normal shipping ETA of 5 to 8 weeks.

Feel free to contact us at:
support@jlelectronicsph.com

Kindly check your spam or junk folder if you haven't received any response. Thank you

Prices are subject to change without prior notice.

****

Share