Sylph-D400M TPA3255 PBTL Mono 400W-2Ω Single Supply RTR Amplifier Module

$112.00 USD Sold Out

TPA3255 based, mono class-D amplifier with 2 ohms load capability. With careful parts selection and some tweaks for superb sound quality.

The board has a passive PFFB configuration similar to SLAA788A. PFFB can be enabled/disabled through onboard jumpers.

The analog input can accept full balanced or single ended signals which can be configured by onboard jumpers. The output is 1 channel, mono PBTL configuration.

Input buffer's gain has been increased (compared to EVM with unity gain)

A split supply is used in the opamp buffer in order to delete the frontend input coupling caps in the buffer stage. The positive and negative rails for opamp supply are being generated on-board with post regulators. The opamp buffer section has a separate bulk cap on its positive and negative rails.

Includes TVS diode for power supply surge protection, and will normally fail short when an accidental reverse polarity is applied.

Use of oversized capacitors and resistors for the zobel network to ensure reliable operation in PFFB mode. Use of bulk capacitance in AVDD analog TPA3255 supply. Voltage supervisor IC is being used to avoid large turn on-off pops or clicks.

Package Includes
1 pc Sylph-D400M mono Ready To Run module.
4 pc female faston tab connector.
1 pc female 2.54 mm 3 pin connector.

Specifications:
Supply Voltage: 30V DC min to 51V DC max
Power (1% THD+N, 50V): 100W-8Ω, 200W-4Ω, 400W-2Ω
Input sensitivity - SE (PFFB disabled): 1V RMS
Input sensitivity - SE (PFFB enabled): 2V RMS
Input sensitivity - Balanced (PFFB disabled): 2V RMS
Input sensitivity - Balanced (PFFB enabled): 4V RMS
Input impedance: 10K Ω
Input configuration: SE / Balanced (header jumper)
Load impedance: 2Ω, 4Ω, or 8Ω
Footprint: 110mm x 100mm x 45mm (L * W * H)
Overcurrent /short protection: Yes
Over voltage protection: No
Overheat protection: Yes
Turn on-off pop suppression: Yes
Gross packed weight: 450g

Recommended Power Supply
(NOT INCLUDED)
- Single supply 50V SMPS 350W or higher.
- DO NOT use power supply with split rails.
- LRS-350-48 or SE-450-48 adjusted to 50V
- Use 43V for unregulated supplies

Shipping
Shipments are consolidated once a week. Kindly wait for the tracking info to become available. Courier is a European Postal affiliated company with normal shipping ETA of 5 to 8 weeks.

Feel free to contact us at:
support@jlelectronicsph.com

Kindly check your spam or junk folder if you haven't received any response. Thank you

Prices are subject to change without prior notice.

****

Share