TICore260BTL TPA3251 non-PFFB BTL Stereo 36V (Partial Kit) Amplifier Module

$67.00 USD - $84.00 USD

Uses Infineon's OptiReg TLS205B0 24 µVRMS, 500mA linear post regulator for 12V supply, which produces clean and quiet power for the input opamps and low noise floor for a TPA3251 based module.

Designed for use with Coilcraft VER2923-682KL flat wire (not included), low loss inductors to get the most out of the TPA3251's THD+N performance. The output inductors run cool and dissipate very little heat on idle.

The analog input can accept full balanced or single ended signals which can be configured by a solder jumper under the PCB. The output is 2 channel, stereo BTL configuration.

A separate voltage supervisor IC is used to mute the amp in power on, and power off.

Use of oversized capacitors and resistors for the zobel network to ensure reliable operation and better sound quality.

Package Includes
1 pc stereo BTL non-PFFB partial module.
6 pc female faston tab connector.
2 pc female 2.54 mm 3 pin connector.
2 pc compatible heatsink screws and washers.

Specifications
Recommended Voltage: 36V DC only
Output Power (<1% THD+N): 50W-8Ω, 100W-4Ω
Voltage gain: 20x (~26dB)
Input sensitivity: 1V RMS
Input impedance: 10K Ω
Input configuration: SE / Balanced input jumper
Load impedance: 4Ω or 8Ω
Idle dissipation: ~5W at 36V DC
Footprint: 148mm x 100mm x 55mm (L * W * H)
Number of PCB Layers: 2 layer copper
Overcurrent /short protection: Yes
Over voltage protection: Yes
Overheat protection: Yes
Turn on-off pop suppression: Yes
Gross packed weight: 250g

Other Specs
Transient voltage protection: 48V TVS + 40.7V SCR
Zobel network values: 1Ω + 220nF
Compatible Heatsink: ATS-TI1OP-519-C1-R3
Compatible Inductors: VER2923, AGP2923, 7G23A

Recommended Power Supply (NOT INCLUDED)
- Single supply SMPS 36V DC, 200W or higher.
- Should be able to handle large load capacitance
and should normally operate on light load (~5W).

-----------------------------------------
This partially assembled module will be completed and will be ready to run after these parts are installed.
(NOT INCLUDED)
- 1pc heatsink: ATS-TI1OP-519-C1-R3
- 4pc tank caps: 1800uF 50V low impedance
- 4pc output inductors: VER2923-682KL
- Thermal Grease: Arctic MX2 or better

-- Shipping --
Shipping consolidation happens once a week. Kindly wait for up to 5 business days for the tracking info to become available. Courier is a European Postal affiliated company with normal shipping times of 3 to 6 weeks (Max 8 weeks depending on Covid situation).

Contact us for actual shipping amount of combined items.
support@jlelectronicsph.com

Kindly check your spam or junk folder if you haven't received any response.

Share